TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1884-05 Winch Spool In
7. Check for active code 1884-05 or
Code 1884-05 Remains Active - Pro-
Solenoid Current Below Nor-
1884-06 in machine control D6K
ceed to Test Step 3.
mal - Continued
ECM (WP 0016).
Code 1884-05 Becomes Inactive
and 1884-06 Becomes Active - Turn
ignition switch and battery disconnect
switch to OFF position (TM 5-2410-
240-10).
Remove jumper wire from EN-C21
terminal 2 and terminal 6 (WP 0018,
Figure 137).
Replace pump wiring harness (WP
0046).
Proceed to step 8.
8. Using MSD (WP 0016), select
Code 1884-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1884-05 is not active.
Code 1884-05 Not Active - Trouble-
shooting complete.
Test Step 3. Test for Open Engine
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove jumper wire from EN-
C21 terminal 2 and terminal 6
(WP 0018, Figure 137).
3. Disconnect engine wiring har-
ness connector EN-C50 (WP
0018, Figure 140) from platform
wiring harness connector PL-C32
(WP 0018, Figure 232) (WP
0046).
4. Connect jumper wire between PL-
C32 terminal 2 and 3 (WP 0018,
Figure 232).
5. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
0023-94