TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
1933-05 Blade Angle Left
Solenoid Current Below Nor-
Always inspect harness connectors thatare involved in the circuit. Poor
mal
connections can often be the cause of an electrical circuit problem. Ver-
ify that all connections in circuit are clean and secure, and connections
are in good condition. If problem with connection is found, correct the
problem and verify diagnostic code is active before performing this pro-
cedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
Test Step 1. Test for Open Blade
Angle Left Solenoid.
1. Connect MSD (WP 0016), select
machine control D6K ECM and
verify 1933-05 is active.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. For D6K Dozer with Ripper,
remove rear plates from machine
to access valve bank (WP 0196).
For D6K Dozer with Winch,
remove rear bottom guards (WP
0156) from machine to access
valve bank (WP 0197).
4. Disconnect chassis wiring har-
ness connector CH-C23 from
blade angle left solenoid: with
Ripper (WP 0018, Figure 96); with
Winch (WP 0018, Figure 267).
5. Connect jumper wire between
CH-C23 terminal 1 and terminal 2:
with Ripper (WP 0018, Figure 96);
with Winch (WP 0018, Figure
267).
6. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).