TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1934-05 Blade Angle Right
4. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
Solenoid Current Below Nor-
0283), measure resistance
Proceed to Test Step 4.
mal - Continued
between PL-C2 terminal 48 (WP
Resistance 5.0 Ohms or Greater -
0018, Figure 215) and PL-C18
Replace platform wiring harness: with
terminal 8 (WP 0018, Figure 226).
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C22 on blade angle right
solenoid: with Ripper (WP 0018, Fig-
ure 95); with Winch (WP 0018, Figure
266).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 5.
5. Using MSD (WP 0016), select
Code 1934-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1934-05 is not active.
Code 1934-05 Not Active - Trouble-
shooting complete.
0023-160