TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1934-06 Blade Angle Right
6. Check for active code 1934-05 or
Code 1934-06 Remains Active - Pro-
Solenoid Current Above
1934-06 in machine control D6K
ceed to Test Step 2.
Normal - Continued
ECM (WP 0016).
Code 1934-06 Becomes Inactive
and 1934-05 Becomes Active -
Replace blade angle right solenoid:
with Ripper (WP 0196); with Winch
(WP 0197).
Proceed to step 7.
7. Using MSD (WP 0016), select
Code 1934-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1934-06 is not active.
Code 1934-06 Not Active - Trouble-
shooting complete.
Test Step 2. Test for Shorted Chas-
sis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove right rear access cover
from machine (WP 0191).
3. Disconnect platform wiring har-
ness connector PL-C18 (WP
0018, Figure 226) from chassis
wiring harness connector CH-C1
(WP 0018, Figure 81): with Ripper
(WP 0150); with Winch (WP
0155).
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
Code 1934-06 Remains Active - Pro-
5. Check for active code 1934-05 or
ceed to Test Step 3.
1934-06 in machine control D6K
ECM (WP 0016).
Code 1934-06 Becomes Inactive
and 1934-05 Becomes Active -
Replace fuel tank and chassis wiring
harness: with Ripper (WP 0153); with
Winch (WP 0154).
Proceed to step 6.
6. Using MSD (WP 0016), select
Code 1934-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1934-06 is not active.
Code 1934-06 Not Active - Trouble-
shooting complete.
0023-163
