TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1934-06 Blade Angle Right
6. Using digital multimeter (WP
No Continuity on Any Test Points -
Solenoid Current Above
0283), test for continuity between
Proceed to step 7.
Normal - Continued
PL-C2 terminal 48 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C5
Points - Replace platform wiring har-
(WP 0018, Figure 218).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C22 on blade angle right
solenoid: with Ripper (WP 0018, Fig-
ure 95); with Winch (WP 0018, Figure
266).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
7. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 8.
PL-C2 terminal 48 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C4
Points - Replace platform wiring har-
(WP 0018, Figure 217).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C22 on blade angle right
solenoid: with Ripper (WP 0018, Fig-
ure 95); with Winch (WP 0018, Figure
266).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 9.
0023-165