TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2211-03 Auxiliary Valve #1
5. Using digital multimeter (WP
No Continuity on Any Test Points -
Port B Solenoid Voltage
0283), test for continuity between
Proceed to step 6.
Above Normal - Continued
PL-C2 terminal 42 and all other
Continuity on One or More Test
circuits in PL-C2 (WP 0018, Fig-
Points - Replace platform wiring har-
ure 215).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Proceed to step 8.
6. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 7.
PL-C2 terminal 42 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C5
Points - Replace platform wiring har-
(WP 0018, Figure 218).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Proceed to step 8.
7. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to Test Step 3.
PL-C2 terminal 42 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C4
Points - Replace platform wiring har-
(WP 0018, Figure 217).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Proceed to step 8.
8. Using MSD (WP 0016), select
Code 2211-03 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2211-03 is not active.
Code 2211-03 Not Active - Trouble-
shooting complete.
Test Step 3. Test J914-PU Ripper
Lower Solenoid Circuit for Short to
Other Voltage Source in Platform
Wiring Harness.
1. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
0023-169