TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3187-04 Auxiliary Valve #1
7. Using digital multimeter (WP
No Continuity on Test Point - Pro-
Port B Solenoid Voltage
0283), test for continuity between
ceed to Test Step 3.
Below Normal - Continued
CH-C1 terminal 15 (WP 0018,
Continuity on Test Point - Replace
Figure 81) and ground.
chassis wiring harness: with Ripper
(WP 0153); with Winch (WP 0154).
Proceed to step 8.
8. Using MSD (WP 0016), select
Code 3187-04 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 3187-04 is not active.
Code 3187-04 Not Active - Trouble-
shooting complete.
Test Step 3. J913-GN Lower Sole-
noid Return Circuit for Short to
Other Circuits in Platform Wiring
Harness.
1. Disconnect platform wiring har-
ness connector PL-C2 (WP 0018,
Figure 215) from equipment ECM
(WP 0148).
2. Disconnect platform wiring har-
ness connector PL-C5 (WP 0018,
Figure 218) from ECM J2: with
Ripper (WP 0147); with Winch
(WP 0149).
3. Disconnect platform wiring har-
ness connector PL-C4 (WP 0018,
Figure 217) from ECM J1: with
Ripper (WP 0147); with Winch
(WP 0149).
4. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 5.
PL-C2 terminal 43 and all other
Continuity on One or More Test
circuits in PL-C2 (WP 0018, Fig-
Points - Replace platform wiring har-
ure 215).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C3 on auxiliary valve #1
port B solenoid (WP 0018, Figure 83).
For D6K Dozer with Ripper, install
rear plates (WP 0196) on machine.
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 8.
0023-173