TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3196-04 Blade Angle Right
6. Using digital multimeter (WP
No Continuity on Any Test Points -
Solenoid Voltage Below Nor-
0283), test for continuity between
Proceed to step 7.
mal - Continued
PL-C2 terminal 49 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C4
Points - Replace platform wiring har-
(WP 0018, Figure 217).
ness: with Ripper (WP 0150); with
Winch (WP 0155).
Connect chassis wiring harness con-
nector CH-C22 on blade angle right
solenoid: with Ripper (WP 0018, Fig-
ure 95) or with Winch (WP 0018, Fig-
ure 266).
For D6K with Ripper, install rear
plates on machine (WP 0196). For
D6K with Winch, install rear bottom
guards on machine (WP 0156).
Proceed to step 8.
0023-155