TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2211-05 Auxiliary Valve #1
Test Step 4. Test J913-GY Lower
Port B Solenoid Current
Solenoid Return Circuit for High
Below Normal - Continued
Resistance or Open in Platform
Wiring Harness.
1. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Replace equipment ECM (WP 0148).
between PL-C2 terminal 43 (WP
Connect platform wiring harness con-
0018, Figure 215) and PL-C18
nector PL-C5 (WP 0018, Figure 218)
terminal 15 (WP 0018, Figure
on ECM J2: with Ripper (WP 0147);
226).
with Winch (WP 0149).
Connect platform wiring harness con-
nector PL-C4 (WP 0018, Figure 217)
on ECM J1: with Ripper (WP 0147);
with Winch (WP 0149).
Connect platform wiring harness con-
nector PL-C18 (WP 0018, Figure 226)
on chassis wiring harness connector
CH-C1 (WP 0018, Figure 81): with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C3 on auxiliary valve #1
port B solenoid (WP 0018, Figure 83).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Replace platform wiring harness: with
Ripper (WP 0150); with Winch (WP
0155).
Connect chassis wiring harness con-
nector CH-C3 on auxiliary valve #1
port B solenoid (WP 0018, Figure 83).
For D6K Dozer with Ripper, install
rear plates on machine (WP 0196).
For D6K Dozer with Winch, install rear
bottom guards on machine (WP
0156).
Proceed to step 2.
0023-180