TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 5. Test U717-OR Drive-
2482-06 Winch Drive Away
Away Solenoid Supply Circuit for
Solenoid Current Above
Short to Other Circuits in WInch
Normal - Continued
Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Remove winch from machine (WP
0265).
3. Disconnect winch wiring harness
connector WF-C3 (WP 0018, Fig-
ure 255) from drive-away solenoid
(WP 0018, Figure 258) (WP
0266).
4. Disconnect winch wiring harness
connector WF-C2 (WP 0018, Fig-
ure 254) from free-spool solenoid
(WP 0018, Figure 257) (WP
0266).
5. Disconnect winch wiring harness
connector WF-C5 (WP 0018, Fig-
ure 256) from brake solenoid (WP
0018, Figure 259) (WP 0266).
6. Inspect winch wiring harness for
No Damage Found - Proceed to
damage (WP 0283).
step 7.
Damage Found - Replace winch wir-
ing harness (WP 0265).
Proceed to step 8.
7. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Replace drive-away solenoid (WP
WF-C1 terminal 3 and all other
0266).
circuits in WF-C1 (WP 0018, Fig-
Proceed to step 8.
ure 253).
Continuity on One or More Test
Points - Replace winch wiring har-
ness (WP 0265).
Proceed to step 8.
8. Using MSD (WP 0016), select
Code 2482-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2482-06 is not active.
Code 2482-06 Not Active - Trouble-
shooting complete.
END OF WORK PACKAGE
0023-281/(282 blank)