TM 5-2410-240-23-2
0061
CLEANING AND INSPECTION
00061
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0282).
END OF TASK
INSTALLATION
00061
N OT E
Install tubes and hoses as noted during removal.
Do not tighten until each nut and bolt is installed.
1. Remove caps and install tube assembly (Figure 8, Item 2) on eight clips (Figure 8, Item 9).
2. Install new washer (Figure 8, Item 5), tube assembly (Figure 8, Item 2), new washer (Figure 8, Item 3), and
fluid passage bolt (Figure 8, Item 4) on secondary fuel filter base (Figure 8, Item 6) finger tight.
3. Install tube nut (Figure 8, Item 8) on fuel rail (Figure 8, Item 7) finger tight.
4. Tighten fluid passage bolt (Figure 8, Item 4) and tube nut (Figure 8, Item 8) to 11 lb-ft (15 Nm).
5. Remove caps and connect tube assembly (Figure 8, Item 2) on fuel injection pump (Figure 8, Item 1).
6. Remove caps and connect hose (Figure 8, Item 10) on tube assembly (Figure 8, Item 2).
Figure 8. Tube Assembly.
0061