TM 5-2410-240-23-2
0061
INSTALLATION CONTINUED
N OT E
Install tube as noted during removal.
Do not tighten until each nut and bolt is installed.
14. Remove caps and install tube (Figure 13, Item 4) on three clips (Figure 13, Item 5).
15. Install tube nut (Figure 13, Item 3) on cylinder head (Figure 13, Item 2) finger tight.
16. Install new washer (Figure 13, Item 8), tube (Figure 13, Item 4), new washer (Figure 13, Item 7), and fluid
passage bolt (Figure 13, Item 6) on fuel injector pump (Figure 13, Item 1).
17. Tighten fluid passage bolt (Figure 13, Item 6) and tube nut (Figure 13, Item 3) to 11 lb-ft (15 Nm).
Figure 13. Fuel Injector Pump to Cylinder Head Tube.
0061