TM 5-2410-240-23-2
0100
REMOVAL
000100
N OT E
Oil pump must be replaced as a unit if any part of oil pump is worn or damaged.
1. Remove two bolts (Figure 1, Item 4) retaining suction pipe (Figure 1, Item 3) on oil pump (Figure 1, Item 5).
2. Remove bolt (Figure 1, Item 2) retaining pipe clip (Figure 1, Item 1) on bracket (Figure 1, Item 10).
3. Remove suction pipe (Figure 1, Item 3) and gasket (Figure 1, Item 7) from oil pump (Figure 1, Item 5). Discard
gasket.
4. Remove pipe clip (Figure 1, Item 1) from suction pipe (Figure 1, Item 3).
5. Remove bolt (Figure 1, Item 9) and bracket (Figure 1, Item 10) from cylinder block (Figure 1, Item 8).
6. Remove four bolts (Figure 1, Item 6) and oil pump (Figure 1, Item 5) from cylinder block (Figure 1, Item 8).
Figure 1. Oil Pump, Suction Pipe, and Retaining Hardware.
0100
END OF TASK
CLEANING AND INSPECTION
000100
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0282).
END OF TASK