TM 5-2410-240-23-2
0165
HYDRAULIC SYSTEM FILTER BASE INSTALLATION
000165
N OT E
Hydraulic filter bases are installed using the same general method. This procedure
describes installation of one filter base.
1. Install cap (Figure 9, Item 3), new O-ring (Figure 9, Item 5), connector (Figure 9, Item 2), new O-ring (Figure 9,
Item 6), and vent (Figure 9, Item 1) on tee (Figure 9, Item 4).
Figure 9. Tee, Connector, and Base.
0165
N OT E
Install tee fitting as noted during removal.
2. Install new O-ring (Figure 10, Item 5), connector (Figure 10, Item 2), new O-ring (Figure 10, Item 4), and tee
(Figure 10, Item 3) on filter base (Figure 10, Item 1).
Figure 10. Tee, Connector, and Base.
0165