TM 5-2410-240-23-2
0165
HYDRAULIC SYSTEM FILTER BASE REMOVAL CONTINUED
N OT E
Note position of tee fitting to aid installation.
10. Remove tee (Figure 6, Item 3), O-ring (Figure 6, Item 4), connector (Figure 6, Item 2), and O-ring (Figure 6,
Item 5) from filter base (Figure 6, Item 1). Discard O-rings.
Figure 6. Tee, Connector, and Base.
0165
11. Remove vent (Figure 7, Item 1), O-ring (Figure 7, Item 6), connector (Figure 7, Item 2), O-ring (Figure 7,
Item 5), and cap (Figure 7, Item 3) from tee (Figure 7, Item 4). Discard O-rings.
Figure 7. Tee and Connector.
0165
END OF TASK