TM 5-2410-240-23-3
0178
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
To prevent injury to personnel, wear protective eye covering and gloves.
Lubricating/hydraulic oils used in perfomance of maintenance can be very slippery.
r
Immediately wipe up any spills. Failure to follow this warning may result in injury to
personnel.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Cap all hydraulic openings along with component connections during removal to protect
against contamination. Failure to follow this caution may cause damage to equipment.
N OT E
Use a container to catch any fluid that maydrain from hoses or system. Dispose of fluid
IAW local policy and ordinances. Ensure all spills are cleaned up.
Note routing of wiring harness to aid installation.
REMOVAL
000178
1. Disconnect harness connector (Figure 1, Item 1) from sensor (Figure 1, Item 2) and position aside.
2. Remove sensor (Figure 1, Item 2) from hydraulic tank (Figure 1, Item 3). Discard gasket.
0178-2
