TM 5-2410-240-23-3
0188
INSTALLATION CONTINUED
13. If arctic kit heater equipped, measure 2.4 in. (62 mm) up from top of bracket on hood support (Figure 9,
Item 1) and mark hood support.
WARN I N G
Take the following precautions before grinding,cutting, or welding any equipment that has
been CARC-coated:
Wear protective equipment (e.g., goggles, gloves, apron) when grinding or
sanding CARC-coated equipment. DO NOT leave any skin exposed.
Use high-efficiency air-purifying respirators when grinding or sanding CARC-
coated equipment.
Never weld or cut CARC-coated equipment; grind or sand off CARC paint
completely before welding.
CARC paint contains isocyanate (HDI), which is highly irritating to the skin and
respiratory system. High concentrations of HDI can produce itching and reddening
of the skin, a burning sensation in the throat and nose, and watering of the eyes.
In extreme concentrations, HDI can cause coughing, shortness of breath, pain
during respiration, increased sputum production, and chest tightness.
Failure to follow these warnings may result in injury or death to personnel.
14. If arctic kit heater equipped, prepare site IAW welding procedures found in TC 9-237.
15. If arctic kit heater equipped, weld top (Figure 9, Item 2) and bottom (Figure 9, Item 4) of mounting bracket
(Figure 9, Item 3) on hood support (Figure 9, Item 1).
16. If arctic kit heater equipped, preserve site IAW welding procedures found in TC 9-237.
N OT E
Install lines as tagged during removal.
0188-10
