2
TM 5-2410-241-10
OPERATOR MAINTENANCE
-
FUEL SYSTEM - PRIME
0017
Prime Fuel System
INITIAL SETUP
References
Estimated Time to Complete
0
0
0.2 Hr
0
0
Equipment Condition
0
Battery disconnect switch in ON
position (WP 0004)
0
N OT E
If the engine does not start, air may be trapped in the fuel lines to the engine. Use the
following procedure to purge air from the fuel lines.
PRIME FUEL SYSTEM
00017
1. Unlock priming pump plunger (Figure 1, Item 1).
2. Operate plunger until resistance is felt.
3. Push plunger in and hand-tighten to lock plunger in place.
Figure 1. Fuel System Priming Pump.
0017
4. Start engine (WP 0005).
5. If engine fails to start, or if engine starts and misfires or excessive smoke comes from exhaust pipe, additional
priming may be required. Repeat steps 1 through 4.
6. If engine runs rough, allow it to run at low idle until it runs smoothly.
END OF TASK
END OF WORK PACKAGE