TM 5-2410-241-23-1
0019
Table 2. Engine Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
6-11 Cylinder #6 Injector
17. Perform Injector Solenoid Test
1. If "OPEN" displayed, replace
Fault - Continued
engine main wiring harness
(WP 0055). Ensure all harness
connectors are reconnected.
Verify correct operation of
machine (TM 5-2410-241-10).
2. If "SHORT" displayed, replace
engine ECM (WP 0101). Ensure
all harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
18. Connect engine harness connec-
tor N-C2 (WP 0018, Figure 7) on
valve cover side connector NN-
C1 (WP 0018, Figure 8).
19. Remove valve cover (WP 0106),
and disconnect injector wire
(WP 0105) (Figure 7, Item 2).
20. Perform Injector Solenoid Test
1. If "OPEN" displayed, replace fuel
injector (WP 0069). Ensure all
harness connectors are recon-
nected. Verify correct operation of
machine (TM 5-2410-241-10).
2. If "SHORT" displayed, replace
injector wiring harness
(WP 0106). Ensure all harness
connectors are reconnected. Ver-
ify correct operation of machine
(TM 5-2410-241-10).
41-3 8 Volt DC Supply Short
1. If active 41-3 code is present, pro-
1. Connect MSD (WP 0016). Select
to +Batt
ceed to step 2.
3176C D7 engine ECM and check
for Diagnostic Codes or Event
2. If no active codes are present,
Codes (WP 0013).
problem does not exist at this
time. Resume normal operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
3. Disconnect decelerator position
sensor connector E-C28
(WP 0018, Figure 9) from deceler-
ator position sensor (WP 0258).
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-241-10).