TM 5-2410-241-23-2
0102
INSTALLATION CONTINUED
1. Apply lubricating oil on new O-ring (Figure 3, Item 2).
2. Install O-ring (Figure 3, Item 2) on new rear crankshaft seal (Figure 3, Item 3).
3. Align bolt holes (Figure 3, Items 7 and 8) and push rear crankshaft seal (Figure 3, Item 3) squarely on flywheel
housing (Figure 3, Item 1). Plastic sleeve (Figure 3, Item 6) will be forced out of rear crankshaft seal. Discard
plastic sleeve.
Figure 3. Rear Crankshaft Seal, O-ring Seal, Plastic Sleeve, and Retaining Hardware.
0102
WARN I N G
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can
cause lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety
goggles and use product in a well-ventilated area away from open flame. If ingested, keep
individual calm and seek medical attention. DO NOT induce vomiting. If contact with skin
or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW local policy and
ordinances. Failure to follow this warning may cause injury to personnel.
4. Apply sealing compound on threads of nine bolts (Figure 3, Item 5).
5. Install nine washers (Figure 3, Item 4) and bolts (Figure 3, Item 5) retaining rear crankshaft seal (Figure 3,
Item 3) on flywheel housing (Figure 3, Item 1).