4
TM 5-2410-241-23-2
FIELD MAINTENANCE INSTRUCTIONS
-
HYDRAULIC OIL SERVICE
0
184
Hydraulic System Oil Change
INITIAL SETUP
Materials/Parts-Continued
Tools and Special Tools
0
0
Tool Kit, General Mechanic's
Oil, Lubricating OE/HDO-30
(WP 0302, Item 65)
(WP 0303, Item 19)
0
0
Swivel, Hydraulic Tank Drain
Rag, Wiping (WP 0303, Item 24)
0
(WP 0302, Item 60)
Container (25 gallon capacity)
0
0
Wrench, Torque, Click, Ratcheting, 1/2" Drive,
Hose 1" ID x 6' Length
0
250 lb-ft (WP 0302, Item 71)
0
References
0
Materials/Parts
0
LO 5-2410-241-13
0
Oil, Lubricating OEA, Arctic
TM 5-2410-241-10
0
(WP 0303, Item 17)
0
Estimated Time to Complete
Oil, Lubricating OE/HDO-10
0
(WP 0303, Item 18)
1.5 Hr
0
0
HYDRAULIC SYSTEM OIL CHANGE
000184
WARN I N G
Oil should be warm to ensure it drains competely. Use caution to protect against burns,
l
when draining oil. Failure to follow this warning may cause injury.
Contact with oil can damage skin. Wear gloveswhen handling oil. If oil contacts skin, wash
it off immediately. Failure to follow this warning may cause injury to personnel.
Lubricating oil is very slippery. Immediaely wipe up any spills. Failure to follow this
t
warning may cause injury.
At operating temperature, the hydrauic tank is hot and under pressure.
l
Hot oil and components can cause personal injury. Do not allow hot oil or components to
contact skin.
Remove the filler cap slowly only when theengine is stopped and the filler cap is cool
enough to touch with your bare hand. Remove the filler cap slowly to relieve pressure.
Failure to follow these warnings may cause injury or death to personnel.
N OT E
Care must be taken to ensure that fluids ae contained during performance of inspection,
r
maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid
with suitable containers before opening any compartment or disassembling any
component containing fluids.
Dispose of all fluids accordingto local regulations and mandates.
0184-1
