TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
2305-03 Brake/Decelerator Pedal
Position Sensor Voltage Above Nor-
Always inspect harness connectors that are involved in circuit.
mal
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Disconnect harness connec-
tor PC-8 (WP 0018, Figure
202) from service brake posi-
tion sensor.
3. Turn battery disconnect switch
and ignition switch to ON posi-
tion (TM 5-2410-240-10).
4. Using digital multimeter, mea-
Voltage Less Than Specified
sure for voltage (WP 0283)
Range - Proceed to step 6.
between harness connector
Voltage Within Specified Range
PC-8 (WP 0018, Figure 202)
- Proceed to step 5.
terminals A and B.
There should be approximately
8 volts 0.5 volts.
5. Using digital multimeter, mea-
Voltage Less Than Specified
sure for voltage (WP 0283)
Range - Proceed to step 6.
between harness connector
Voltage Within Specified Range
PC-8 (WP 0018, Figure 202)
- Replace service brake position
terminal B and C.
sensor (WP 0243). Ensure all har-
There should be approximately 5
ness connectors are reconnected.
volts 0.5 volts.
Verify proper operation of machine
(TM 5-2410-240-10).
6. Turn the ignition switch and
battery disconnect switch to
the OFF position (TM 5-2410-
240-10).
7. Disconnect harness connec-
tor C-C38 (WP 0018, Figure
29) from P-C1 (WP 0018, Fig-
ure 197).
