TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2204-04 Auxiliary Lever #1 Position
17. Using digital multimeter, test
No Continuity - Replace machine
Sensor Voltage Below Normal - Con-
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
tinued
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 49 and all other termi-
tion of machine (TM 5-2410-240-
nals in harness connector PL-
10).
C5 (WP 0018, Figure 218).
Continuity - Replace platform wir-
ing harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
N OT E
2204-08 Auxiliary Lever #1 Position
Sensor Abnormal Frequency, Pulse
Always inspect harness connectors that are involved in circuit.
Width, or Period
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Disconnect harness connec-
tor C-C49 (WP 0018, Figure
36) from ripper joystick.
3. Turn battery disconnect switch
and ignition switch to ON posi-
tion (TM 5-2410-240-10).
4. Using digital multimeter, mea-
Voltage Less Than Specified
sure for voltage (WP 0283)
Range - Proceed to step 6.
between harness connector
Voltage Within Specified Range
C-C49 (WP 0018, Figure 36)
- Proceed to step 5.
terminal 1 and 2.
There should be approximately
10 volts 0.5 volts.
5. Using digital multimeter, mea-
Voltage Less Than Specified
sure for voltage (WP 0283)
Range - Proceed to step 6.
between harness connector
Voltage Within Specified Range -
C-C49 (WP 0018, Figure 36)
Replace ripper joystick
terminals 2 and 3.
(WP 0218). Ensure all harness
There should be approximately
connectors are reconnected. Verify
5 volts 0.5 volts.
proper operation of machine (TM
5-2410-240-10).