TM 5-2410-240-23-1
0022
Table 1. Window Wiper and Washer Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Right Door Wiper Does
12. Using digital multimeter, test for
No Continuity - Replace right door
continuity (WP 0283) between
Not Operate Properly
wiper motor jumper harness (WP
right door wiper motor jumper har-
Continued
0229). Ensure all harness connectors
ness connector RW-C1 (WP
are reconnected. Verify proper opera-
0018, Figure 240) terminal 4 and
tion of machine (TM 5-2410-240-10).
right door wiper motor harness
Continuity - Proceed to step 13.
connector RW-C2 (WP 0018, Fig-
ure 241) terminal 4.
13. Using digital multimeter, test for
No Continuity - Replace right door
continuity (WP 0283) between
wiper motor jumper harness (WP
right door wiper motor jumper har-
0209). Ensure all harness connectors
ness connector RW-C1 (WP
are reconnected. Verify proper opera-
0018, Figure 240) terminal 3 and
tion of machine (TM 5-2410-240-10).
right door wiper motor harness
Continuity - Proceed to step 14.
connector RW-C2 (WP 0018, Fig-
ure 241) terminal 3.
14. Disconnect harness connector
PL-C1 (WP 0018, Figure 214)
from harness connector C-C12
(WP 0018, Figure 22).
15. Disconnect harness connector
PL-C3 (WP 0018, Figure 216)
from harness connector FP-C3
(WP 0018, Figure 168).
16. Using digital multimeter, test for
No Continuity - Replace platform
continuity (WP 0283) between
harness (WP 0150, WP 0155).
harness connector PL-C23 (WP
Ensure all harness connectors are
0018, Figure 227) terminal 1 and
reconnected. Verify proper operation
cab ground.
of machine (TM 5-2410-240-10).
Continuity - Proceed to step 17.
17. Using digital multimeter, test for
No Continuity - Replace platform
continuity (WP 0283) between
harness (WP 0150, WP 0155).
harness connector PL-C23 (WP
Ensure all harness connectors are
0018, Figure 227) terminal 4 and
reconnected. Verify proper operation
harness connector PL-C3 (WP
of machine (TM 5-2410-240-10).
0018, Figure 216) terminal 22.
Continuity - Proceed to step 18.
18. Using digital multimeter, test for
No Continuity - Replace platform
continuity (WP 0283) between
harness (WP 0150, WP 0155).
harness connector PL-C23 (WP
Ensure all harness connectors are
0018, Figure 227) terminal 3 and
reconnected. Verify proper operation
harness connector PL-C1 (WP
of machine (TM 5-2410-240-10).
0018, Figure 214) terminal 19.
Continuity - Proceed to step 19.
19. Disconnect right door wiper/
washer switch harness connector
C-C7 (WP 0018, Figure 19) from
right door wiper/washer switch.
0022-41