TM 5-2410-240-23-1
0022
Table 1. Window Wiper and Washer Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Right Door Wiper Does
20. Using digital multimeter, test for
No Continuity - Replace lower cab
Not Operate Properly
continuity (WP 0283) between
wiring harness (WP 0228). Ensure all
Continued
right door wiper/washer switch
harness connectors are reconnected.
harness connector C-C7 (WP
Verify proper operation of machine
0018, Figure 19) terminal 2 and
(TM 5-2410-240-10).
harness connector C-C12 (WP
Continuity - Proceed to step 21.
0018, Figure 22) terminal 19.
21. Remove fuse #11 (TM 5-2410-
240-10).
22. Using digital multimeter, test for
No Continuity - Replace fuse panel
continuity (WP 0283) between
harness (WP 0201). Ensure all har-
harness connector FP-C3 (WP
ness connectors are reconnected.
0018, Figure 168) terminal 22 and
Verify proper operation of machine
upper terminal of fuse #11 (TM 5-
(TM 5-2410-240-10).
2410-240-10).
Continuity - Proceed to step 23.
23. Disconnect harness connector C-
C40 (WP 0018, Figure 30) from
harness connector FP-C5 (WP
0018, Figure 170).
24. Using digital multimeter, test for
No Continuity - Replace fuse panel
continuity (WP 0283) between
harness (WP 0201). Ensure all har-
harness connector FP-C5 (WP
ness connectors are reconnected.
0018, Figure 170) terminal 12 and
Verify proper operation of machine
upper terminal of fuse #11 (TM 5-
(TM 5-2410-240-10).
2410-240-10).
Continuity - Proceed to step 25.
25. Using digital multimeter, test for
No Continuity - Replace lower cab
continuity (WP 0283) between
wiring harness (WP 0228). Ensure all
right door wiper/washer switch
harness connectors are reconnected.
harness connector C-C7 (WP
Verify proper operation of machine
0018, Figure 19) terminal 3 and
(TM 5-2410-240-10).
harness connector C-C40 (WP
Continuity - Replace right door wiper/
0018, Figure 30) terminal 12.
washer switch (WP 0212). Ensure all
harness connectors are reconnected.
Verify proper operation of machine
(TM 5-2410-240-10).
Test Step 3.
1. Disconnect right door wiper motor
harness connector RW-C2 (WP
0018, Figure 241) from right door
wiper motor.
2. Turn right door wiper/washer con-
trol to ON position (TM 5-2410-
240-10).
0022-42