TM 5-2410-240-23-1
0022
Table 1. Window Wiper and Washer Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Right Door Wiper Does
11. Disconnect harness connector
Not Operate Properly
CH-C1 (WP 0018, Figure 81) from
Continued
harness connector PL-C18 (WP
0018, Figure 226).
12. Using digital multimeter, test for
No Continuity - Replace chassis har-
continuity (WP 0283) between
ness (WP 0153, WP 0154). Ensure all
harness connector CH-C26 (WP
harness connectors are reconnected.
0018, Figure 97) terminal 5 and
Verify proper operation of machine
harness connector CH-C1 (WP
(TM 5-2410-240-10).
0018, Figure 81) terminal 36.
Continuity - Proceed to step 12.
13. Using digital multimeter, test for
No Continuity - Replace chassis har-
continuity (WP 0283) between
ness (WP 0153, WP 0154). Ensure all
harness connector CH-C26 (WP
harness connectors are reconnected.
0018, Figure 97) terminal 2 and
Verify proper operation of machine
harness connector CH-C1 (WP
(TM 5-2410-240-10).
0018, Figure 81) terminal 33.
Continuity - Proceed to step 14.
14. Disconnect harness connector
PL-C1 (WP 0018, Figure 214)
from harness connector C-C12
(WP 0018, Figure 22).
15. Using digital multimeter, test for
No Continuity - Replace platform
continuity (WP 0283) between
harness (WP 0150, WP 0155).
harness connector PL-C18 (WP
Ensure all harness connectors are
0018, Figure 226) terminal 36 and
reconnected. Verify proper operation
harness connector PL-C1 (WP
of machine (TM 5-2410-240-10).
0018, Figure 214) terminal 31.
Continuity - Proceed to step 16.
16. Using digital multimeter, test for
No Continuity - Replace platform
continuity (WP 0283) between
harness (WP 0150, WP 0155).
harness connector PL-C18 (WP
Ensure all harness connectors are
0018, Figure 226) terminal 33 and
reconnected. Verify proper operation
cab ground.
of machine (TM 5-2410-240-10).
Continuity - Proceed to step 17.
17. Disconnect right door wiper/
washer switch harness connector
C-C7 (WP 0018, Figure 19) from
right door wiper/washer switch.
18. Using digital multimeter, test for
No Continuity - Replace lower cab
continuity (WP 0283) between
wiring harness (WP 0228). Ensure all
right door wiper/washer switch
harness connectors are reconnected.
harness connector C-C7 (WP
Verify proper operation of machine
0018, Figure 19) terminal 6 and
(TM 5-2410-240-10).
harness connector C-C12 (WP
Continuity - Proceed to step 19.
0018, Figure 22) terminal 31.
0022-49
