TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
2268-04 Winch Free Spool
Solenoid Voltage Below Nor-
Always inspect harness connectors thatare involved in the circuit. Poor
mal
connections can often be the cause of an electrical circuit problem. Ver-
ify that all connections in circuit are clean and secure, and connections
are in good condition. If problem with connection is found, correct the
problem and verify diagnostic code is active before performing this pro-
cedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
Test Step 1. Test J809-BK Free-
Spool Solenoid Return Circuit for
Short to Other Circuits in Winch
Solenoid Wiring Harness.
1. Connect MSD (WP 0016). Select
machine control D6K ECM and
verify 2268-04 is active.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Remove rear bottom guards from
machine (WP 0156).
4. Disconnect winch wiring harness
connector WF-C1 (WP 0018, Fig-
ure 253) from winch solenoid wir-
ing harness connector WC-C3
(WP 0018, Figure 250) (WP
0137).
5. Remove right rear access cover
from machine (WP 0191).
6. Disconnect winch solenoid wiring
harness connector WC-C2 (WP
0018, Figure 249) from platform
wiring harness connector PL-C33
(WP 0018, Figure 233) (WP
0137).