TM 5-2410-240-23-2
0047
INSTALLATION CONTINUED
WARN I N G
Plus and minus symbols are stamped in NATO slave near battery cable terminal
connectors. Install NATO slave on bracket so positive terminal connector faces rear of
machine and negative terminal connector faces front of machine. Failure to follow this
warning may result in injury or death to personnel or damage to equipment.
C AU T I O N
Seat raised lip on inner gasket in hole on bracket before tightening retaining hardware.
Failure to follow this caution may result in damage to inner gasket.
N OT E
Install gasket as noted during removal.
Install tether as noted during removal.
11. Install new outer gasket (Figure 7, Item 9), NATO slave (Figure 7, Item 3), tether (Figure 7, Item 15), four
washers (Figure 7, Item 8), and bolts (Figure 7, Item 7), on bracket (Figure 7, Item 10).
N OT E
Install gasket as noted during removal.
Install tether as noted during removal.
12. Install new inner gasket (Figure 7, Item 11), four washers (Figure 7, Item 12), and nuts (Figure 7, Item 13) on
bracket (Figure 7, Item 10).
13. Install bracket (Figure 7, Item 10) and tighten bolt (Figure 7, Item 14) on machine.
14. Install cap (Figure 7, Item 2) on NATO slave (Figure 7, Item 3).
15. Install tether (Figure 7, Item 15) and screw (Figure 7, Item 1) on cap (Figure 7, Item 2).
16. Install two cables (Figure 7, Item 6), new lockwashers (Figure 7, Item 4), and bolts (Figure 7, Item 5), on NATO
slave (Figure 7, Item 3).
0047-6