TM 5-2410-240-23-2
0136
REMOVAL
000136
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
Lubricating/hydraulic oils used in performance of maintenance can be very slippery.
Immediately wipe up any spills.
Failure to follow these warnings may cause injury or death to personnel.
N OT E
Tag and mark electrical connectors to aid installation.
Note routing of wiring harnesses to aid installation.
1. Remove tiedown strap (Figure 1, Item 1) from winch oil pressure sensor (Figure 1, Item 2), solenoid harness
(Figure 1, Item 5), and sensor harness (Figure 1, Item 6). Discard tiedown strap.
2. Remove tiedown strap (Figure 1, Item 3) from fitting (Figure 1, Item 4) and solenoid harness (Figure 1, Item 5).
Discard tiedown strap.
3. Disconnect sensor harness (Figure 1, Item 6) from solenoid harness (Figure 1, Item 5). Position solenoid
harness aside.
Figure 1. Winch Oil Pressure Sensor, Sensor Harness, Solenoid Harness, and Retaining Hardware.
0136
