TM 5-2410-240-23-2
0164
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
Lubricating/hydraulic oils used in performance of maintenance can be very slippery.
Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to personnel.
REMOVAL
000164
N OT E
Hydraulic system filters are all removed using the same general method. Hydraulic system
filters are serviced as a set. If one filter is to be replaced, replace all filters at the same
time.
1. Position wiping rag underneath hydraulic system filters (Figure 1, Item 2).
2. Remove three hydraulic system filters (Figure 1, Item 2) from filter bases (Figure 1, Item 1).
Figure 1. Hydraulic System Filters.
0164
END OF TASK