TM 5-2410-241-23-1
0021
Table 2. Chassis Troubleshooting Procedures - Continued.
0021
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
248-2 Display Data Link Data
24. Using digital multimeter (WP
1. If continuity is found, replace
Erratic, Intermittent, or
0296), test for continuity between
steering control harness (WP
Incorrect - Continued
pin 10 on powertrain ECM con-
0178). Ensure all harness con-
nector X-C2 (WP 0018, Figure 4)
nectors are reconnected. Verify
and all other pins in powertrain
correct operation of machine (TM
ECM connector X-C2 (WP 0018,
5-2410-241-10).
Figure 4).
2. If continuity is NOT found, pro-
ceed to step 25.
25. Using digital multimeter (WP
1. If continuity is found, replace
0296), test for continuity between
steering control harness (WP
pin 20 on powertrain ECM con-
0178). Ensure all harness con-
nector X-C2 (WP 0018, Figure 4)
nectors are reconnected. Verify
and all other pins in powertrain
correct operation of machine (TM
ECM connector X-C2 (WP 0018,
5-2410-241-10).
Figure 4).
2. If continuity is NOT found, replace
dash monitor ECM (WP 0262).
Ensure all harness connectors
are reconnected. Verify correct
operation of machine (TM 5-2410-
241-10).
271-3 Action Alarm Voltage
1. Connect MSD (WP 0016). Select
1. If active 271-3 code is present,
Above Normal
CAT Monitoring System D7R
proceed to step 2.
ECM and check for Diagnostic
2. If no active codes are present,
Codes or Event Codes (WP
problem does NOT exist at this
time. Resume normal operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
3. Disconnect dash monitor connec-
tor E-C7 (WP 0018, Figure 5)
from instrument panel (WP 0262).
4. Disconnect instrument panel har-
ness action alarm connector E-C3
(WP 0018, Figure 81) from action
alarm (WP 0183).
5. Using digital multimeter (WP
1. If continuity is NOT found, replace
0296), test for continuity between
instrument panel harness
pin 1 on instrument panel harness
(WP 0260). Ensure all harness
action alarm connector E-C3
connectors are reconnected. Ver-
(WP 0018, Figure 81) and pin 4
ify correct operation of machine
on dash monitor connector E-C7
(TM 5-2410-241-10).
(WP 0018, Figure 5).
2. If continuity is found, proceed to
step 6.