TM 5-2410-241-23-1
0035
STEERING HYDRAULIC CIRCUIT TESTS CONTINUED
00035
High Pressure Cutoff Test - Continued
00035
58. Start machine and allow it to run for 15 minutes to reach normal operating temperature (TM 5-2410-241-10).
59. Release parking brake (TM 5-2410-241-10).
60. Set machine to HIGH IDLE (RABBIT MODE) on the throttle switch (TM 5-2410-241-10).
61. Apply service brake (TM 5-2410-241-10).
WARN I N G
Ensure service brake is fully applied prior to position steering control handle in MID
STEER LEFT or RIGHT position. Failure to follow this warning may result in injury or
death to personnel.
62. Pressure gauge (Figure 9, Item 1) should read 5,485 to 5,685 psi (37,800 to 39,200 kPa). Record pressure
readings on gauge.
63. Return steering control handle to NEUTRAL STEER position (TM 5-2410-241-10).
64. Slowly apply steering control handle to MID STEER RIGHT position (TM 5-2410-241-10).
65. Pressure gauge (Figure 9, Item 1) should read 5,485 to 5,685 psi (37,800 to 39,200 kPa). Record pressure
readings on gauge.
Figure 9. Pressure Gauge.
035