TM 5-2410-241-23-1
0035
STEERING HYDRAULIC CIRCUIT TESTS CONTINUED
00035
High Pressure Cutoff Test
00035
36. Ensure implement lockout switch is in LOCK position. Release parking brake (TM 5-2410-241-10).
37. Set machine to HIGH IDLE (RABBIT MODE) on the throttle switch (TM 5-2410-241-10).
38. Apply service brake (TM 5-2410-241-10).
WARN I N G
Ensure service brake is fully applied prior to position steering control handle in MID
STEER LEFT or RIGHT position. Failure to follow this warning may result in injury or
death to personnel.
39. Slowly apply steering control handle to MID STEER LEFT position (TM 5-2410-241-10).
40. Pressure gauge (Figure 7, Item 1) should read 5,485 to 5,685 psi (37,800 to 39,200 kPa). Record pressure
readings on gauge.
41. Return steering control handle to NEUTRAL STEER position (TM 5-2410-241-10).
42. Slowly apply steering control handle to MID STEER RIGHT position (TM 5-2410-241-10).
43. Pressure gauge (Figure 7, Item 1) should read 5,485 to 5,685 psi (37,800 to 39,200 kPa). Record pressure
readings on gauge.
44. Return steering control handle to NEUTRAL STEER position (TM 5-2410-241-10).
45. Release service brake (TM 5-2410-241-10).
46. Set machine to LOW IDLE (TURTLE MODE) on the throttle switch (TM 5-2410-241-10).
47. Apply parking brake (TM 5-2410-241-10).
48. Turn ignition switch and battery disconnect switch to OFF position (TM 5-2410-241-10).
49. If STEER LEFT pressure readings are different from STEER RIGHT pressure readings, replace
counterbalance valve (WP 0217).
50. If STEER LEFT pressure readings and STEER RIGHT pressure readings are the same, but not within
specified range, proceed to step 51.
