TM 5-2410-241-23-2
0118
C AU T I O N
Cap all hydraulic hose ends along with component connections during removal to protect
against contamination. Failure to follow this caution may cause damage to equipment.
FLANGE TYPE HOSE REMOVAL
000118
N OT E
Hydraulic hoses, tubes, fittings, and camps are all removed in generally the same
l
method. This procedure covers removal of one hydraulic hose, and fitting from machine.
Tag and mark all hoses, tubes, lines, and fittings to aid installation.
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid
IAW local policy and ordinances. Ensure all spills are cleaned up.
Note routing of hoses and tubes to aid installation.
Cap all hydraulic hose ends along with comp nent connections during removal to protect
o
against contamination.
This procedure will remove one hose with flangeat each end. Follow the same procedure
for additional hoses with flanges at each end.
1. Remove eight bolts (Figure 1, Item 5), washers (Figure 1, Item 4), and hose (Figure 1, Item 1) from machine.
2. Remove four flanges (Figure 1, Item 3) and two O-rings (Figure 1, Item 2) from hose (Figure 1, Item 1). Discard
O-rings.
0118-2