14
TM 5-2410-241-23-2
FIELD MAINTENANCE
-
POWERTRAIN LINES REPLACEMENT
0118
Flange Type Hose Removal, Flange and Threaded Fitting Type Hose Removal, Threaded Fitting
Type Hose Removal, Cleaning and Inspection, Threaded Fitting Type Hose Installation,
Flange and Threaded Fitting Type Hose Installation, Flange Type Hose Installation
INITIAL SETUP
Tools and Special Tools
References
0
0
Tool Kit, General Mechanic's
WP 0295
0
(WP 0302, Item 65)
0
Equipment Condition
0
Crowfoot Attachment, Socket Wrench, 1-3/8"
Machine parked (TM 5-2410-241-10)
0
(1/2 drive)
(WP 0302, Item 19)
0
Bottom guards removed (WP 0199)
0
Crowfoot Attachment, Socket Wrench, 1-5/8"
Front floor plate removed (WP 0230)
0
(1/2" drive)
Rear floor plate removed (WP 0231)
0
0
(WP 0302, Item 20)
Hydraulic system drained (WP 0184)
0
Gloves, Rubber (S0208)
Drawing Required
0
(WP 0302, Item 68)
0
Goggles (S0209) (WP 0302, Item 68)
0
TM 5-2410-241-24P, Figure 52
0
Wrench, Open End, 1-1/2" and 1-5/8"
Estimated Time to Complete
0
0
(S0853) (WP 0302, Item 68)
5.6 Hr
0
Materials/Parts
0
Cap Set, Protective (WP 0303, Item 4)
0
Rag, Wiping (WP 0303, Item 24)
0
Tag, Marker (WP 0303, Item 34)
0
Tiedown Strap (WP 0303, Item 36)
0
O-ring (11)
0
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot.Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
Lubricating/hydraulic oils used in performa ce of maintenance can be very slippery.
n
Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to personnel.
0118-1
