TM 5-2410-241-23-3
0265
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Engine/hydraulic oils can be very sippery. Immediately wipe up any spills.
l
Wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Cap all hydraulic hose and tube ends along with component connections during removal
to protect against contamination. Failure to follow this caution may cause damage to
equipment.
N OT E
Tag all hoses, tubes, and fittings to aid installation.
Use a container to catch any fluid that maydrain from hoses or system. Dispose of fluid
IAW local policy and ordinances. Ensure all spills are cleaned up.
Note routing of hoses and lines to aid installation.
These procedures cover right lift cylinder hoses. Follow same procedures for left side.
REMOVAL
000265
1. Remove three bolts (Figure 1, Item 2), washers (Figure 1, Item 3), and cover (Figure 1, Item 1) from radiator
guard (Figure 1, Item 4).
Figure 1. Lower Hose Connection Cover.
0265