TM 5-2410-241-23-3
0267
REMOVAL CONTINUED
WARN I N G
Oil is hot at operating temperature.Allow oil to cool before service.
Engine/hydraulic oils, coolant, and fuel can be very slippery. Immediately wipe up any
spills.
Failure to follow these warnings ma result in injury to personnel.
y
2. Use a drain pan to catch oil.
N OT E
When servicing this equipment, performing maintenance, or disposing of materials such
as engine/hydraulic oils, coolant, and fuel, consult your unit/local hazardous waste
disposal center or safety office for local regulatory guidance.
Tag hoses to aid installation.
Cap and plug all hoses and openings.
3. Remove eight bolts (Figure 2, Item 3), washers (Figure 2, Item 4), four flanges (Figure 2, Item 5), two hoses
(Figure 2, Item 2), and O-rings (Figure 2 Item 6) from tilt cylinder (Figure 2, Item 1). Discard O-rings.
Figure 2. Hoses.
0267