TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0002-06 Cylinder #2 Injector Current
4. At MSD, check if all three
0004-05, 0005-05, and 0006-05
Above Normal Continued
diagnostic codes 0004-05,
Diagnostic Codes are Active -
0005-05, and 0006-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
0002-06 Only Active - Proceed to
Test Step 2.
Test Step 2: Isolate problem
with engine control wiring har-
ness.
1. Turn ignition switch to OFF
position (TM 5-2410-240-10).
2. Disconnect E-C12 (WP 0018,
Figure 111) harness connector
from H-C1 (WP 0018, Figure
174) at valve cover base.
3. Turn ignition switch to ON
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
Other fuel injector diagnostic codes may also set, ignore those
codes during this procedure.
4. Start engine or attempt to start
engine (TM 5-2410-240-10).
5. At MSD, check that diagnostic
0002-05 Becomes Active - ECM
code 0002-05 is active
and harness are OK, proceed to
Test Step 3.
0002-06 Remains Active - Pro-
ceed to step 6.
6. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
7. Disconnect ECM harness con-
nector E-C1 (WP 0018, Figure
102) from engine ECM J2.
8. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is shorted. Replace
between engine ECM har-
engine control wiring harness
ness connector E-C1 (WP
(WP 0052). Verify proper operation
0018, Figure 102) terminal 58
of machine (TM 5-2410-240-10).
and all other terminals in
No Continuity - Proceed to step 9.
engine ECM harness connec-
tor E-C1 (WP 0018, Figure
102).
0019-22