TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0003-05 Cylinder #3 Injector Current
10. Using digital multimeter
Continuity - ECM faulty. Replace
Below Normal Continued
(WP 0283), test for continuity
engine ECM (WP 0049).
at engine ECM harness con-
Remove jumper wire from E-C13
nector E-C1 (WP 0018, Figure
(WP 0018, Figure 112) terminal 3
102) between terminal 33 and
and terminal 4.
terminal 59.
Connect E-C13 (WP 0018,
Figure 112) to G-C1 (WP 0018,
Figure 173) at the valve cover
base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052). Verify proper operation
of machine (TM 5-2410-240-10).
Test Step 3: Test Forward Fuel
Injector Harness.
1. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
2. Remove jumper wire from E-
C13 (WP 0018, Figure 112)
harness connector terminal 3
and terminal 4.
3. Using digital multimeter
Resistance Less Than 5.0 Ohms
(WP 0283), test for resistance
- Fuel injector is faulty. Replace
between terminal 3 and termi-
fuel injector #3
nal 4 at G-C1 (WP 0018, Fig-
(WP 0077).
ure 173) harness connector.
Connect E-C13 (WP 0018,
Figure 112) to G-C1 (WP 0018,
Figure 173) at the valve cover
base.
Verify proper operation of machine
(TM 5-2410-240-10).
Resistance 5.0 Ohms or Greater
- Proceed to step 4.
4. Remove valve cover
(WP 0104).
5. Disconnect forward fuel injec-
tor harness terminal G-T11
and terminal G-T22 (WP 0018,
Figure 270) from fuel injector
#3.
0019-27