TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0003-05 Cylinder #3 Injector Current
6. Install jumper wire between
Below Normal Continued
terminal G-T11 and terminal
G-T22 (WP 0018, Figure 270)
of forward fuel injector har-
ness.
7. Using digital multimeter
Continuity (Resistance less than
(WP 0283), test for continuity
5.0 Ohms) - Fuel injector is faulty.
between terminal 3 and termi-
Replace fuel injector #3
nal 4 at G-C1 (WP 0018,
(WP 0077).
Figure 173) harness connec-
Remove jumper wire from termi-
tor.
nal G-T11 and terminal G-T22
(WP 0018, Figure 270).
Connect E-C13 (WP 0018,
Figure 112) to G-C1 (WP 0018,
Figure 173) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Replace forward
fuel injector harness (WP 0104).
Verify proper operation of machine
(TM 5-2410-240-10).
0003-06 Cylinder #3 Injector Current
WARN I N G
Above Normal
Electrical shock hazard. Electronic unit injector system uses 67-
73 Volts. Failure to follow this warning may result in injury to per-
sonnel.
Test Step 1: Test Fuel Injector
and Engine Control Wiring Har-
nesses.
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct the problem and verify diagnostic
code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K.
2. Start engine or attempt to start
engine (TM 5-2410-240-10).