TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0002-06 Cylinder #2 Injector Current
7. Using digital multimeter
Continuity - Forward fuel injector
Above Normal Continued
(WP 0283), test for continuity
harness is shorted. Replace for-
at H-C1 (WP 0018,
ward fuel injector harness
Figure 174) harness connec-
(WP 0104). Verify proper operation
tor terminal 2 and ground.
of machine (TM 5-2410-240-10).
No Continuity - Fuel injector is
faulty. Replace fuel injector #2
(WP 0077).
Connect E-C12 (WP 0018,
Figure 111) to H-C1 (WP 0018,
Figure 174) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
0002-07 Active - Replace fuel
0002-07 Cylinder #2 Injector Not
Connect MSD (WP 0016). Select
injector #2 (WP 0077). Verify
Responding Properly
engine ECM C6.6 D6K. Check for
proper operation of machine
any diagnostic codes (WP 0013).
(TM 5-2410-240-10).
No Active Codes - Problem does
not exist at this time. Resume nor-
mal operation.
0003-02 Cylinder #3 Injector Erratic,
Test Step 1: Check for Fuel
Intermittent, or Incorrect Code
Injector Diagnostic Codes.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K.
2. Start engine or attempt to start
engine (TM 5-2410-240-10).
3. At MSD, check if all three
0001-05, 0002-05, and 0003-05
diagnostic codes: 0001-05,
Diagnostic Codes are Active -
0002-05, and 0003-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
4. At MSD, check if all three
0004-05, 0005-05, and 0006-05
diagnostic codes: 0004-05,
Diagnostic Codes are Active -
0005-05, and 0006-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
0003-02 Only Active - Proceed to
Test Step 2.
Test Step 2: Replace Fuel Injec-
tor.
1. Replace fuel injector #3
(WP 0077).
2. Start and run engine to normal
operating temperature (TM 5-
2410-240-10).
