TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0526-05 Turbo Wastegate Drive Cur-
1. Perform Turbo Wastegate
Turbo Wastegate Solenoid Test
rent Below Normal Continued
Solenoid Test (WP 0028).
Failed with Tested Device Cur-
rent Low - Proceed to step 2.
2. Turn ignition switch to OFF
position (TM 5-2410-240-10).
3. Disconnect harness connec-
tor E-C15 (WP 0018, Figure
114) from the turbocharger
wastegate solenoid.
4. Install jumper wire between
harness connector E-C15
(WP 0018, Figure 114) termi-
nal 2 and ground.
5. Perform Turbo Wastegate
Turbo Wastegate Solenoid Test
Solenoid Test (WP 0028).
Failed with Tested Device Cur-
rent High - Proceed to step 6.
Turbo Wastegate Solenoid Test
Failed with Tested Device Cur-
rent Low - Proceed to Test Step 2.
6. Turn ignition switch to OFF
position (TM 5-2410-240-10).
7. Remove jumper from harness
connector E-C15 (WP 0018,
Figure 114) terminal 2 and
ground.
8. Install jumper wire between
harness connector E-C15
(WP 0018, Figure 114) termi-
nal 1 and terminal 2.
9. Perform Turbo Wastegate
Turbo Wastegate Solenoid Test
Solenoid Test (WP 0028).
Failed with Tested Device Cur-
rent High - Solenoid faulty.
Replace turbocharger wastegate
solenoid (WP 0080).
Remove jumper wire from E-C15
(WP 0018, Figure 114) terminal 1
and terminal 2.
Connect E-C15 (WP 0018, Figure
114) to turbocharger wastegate
solenoid.
Verify proper operation of machine
(TM 5-2410-240-10).
Turbo Wastegate Solenoid Test
Failed with Tested Device Cur-
rent Low - Proceed to Test Step 2.
0019-99