TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0342-08 Speed (Injection Pump Posi- 6. Using digital multimeter
Continuity - Proceed to step 7.
tion) Sensor Abnormal Frequency,
(WP 0283), test the for conti-
No Continuity - Engine control
Pulse Width, or Period Continued
nuity between E-C3
wiring harness is open. Replace
(WP 0018, Figure 104) har-
engine control wiring harness
ness connector terminal 2,
(WP 0052). Verify proper operation
and engine ECM harness con-
of machine (TM 5-2410-240-10).
nector E-C1 (WP 0018,
Figure 102) terminal 53.
7. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is shorted. Replace
between engine ECM har-
engine control wiring harness
ness connector E-C1
(WP 0052). Verify proper operation
(WP 0018, Figure 102) termi-
of machine (TM 5-2410-240-10).
nal 53 and all other terminals
No Continuity - Proceed to step 8.
in engine ECM harness con-
nector E-C1 (WP 0018,
Figure 102).
8. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is shorted. Replace
between engine ECM har-
engine control wiring harness
ness connector E-C1
(WP 0052). Verify proper operation
(WP 0018, Figure 102) termi-
of machine (TM 5-2410-240-10).
nal 53 and ground.
No Continuity - Replace speed
(injection pump position) sensor
(WP 0070).
Connect E-C1 (WP 0018, Figure
102) to engine ECM J2.
Proceed to step 9.
9. Attempt to start engine (TM 5-
Engine Does Not Start - ECM
2410-240-10). Engine should
faulty. Replace engine ECM
start and run.
(WP 0049). Verify proper operation
of machine (TM 5-2410-240-10).
Engine Starts and Runs - Test
complete.
0526-05 Turbo Wastegate Drive Cur-
Test Step 1: Verify Diagnostic
rent Below Normal
Code.
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in the circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct the problem and verify diagnostic
code is active before performing this procedure.
Tag wiring harnesses to aid installation.