TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
N OT E
0041-04 Sensor Power Sup-
ply (8 DCV) Voltage Below
Always inspect harness connectors that are involved in circuit. Poor
Normal
connections can often be the cause of an electrical circuit problem.
Verify connections in circuit are clean, secure, and connections are in
good condition. If a problem with connection is found, correct problem
and verify diagnostic code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
0041-04 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
3. Disconnect chassis harness right
track speed sensor connector
CH-C6 (WP 0018, Figure 85) from
right track speed sensor (WP
0127).
4. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
5. Check for diagnostic codes (WP
0041-04 Code Active - Proceed to
step 6.
0041-04 Code Not Active - Replace
right track speed sensor (WP 0127).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
6. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).
7. Disconnect chassis harness left
track speed sensor connector
CH-C7 (WP 0018, Figure 86) from
left track speed sensor (WP
0127).
8. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).