TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0133-05 Transmission Pilot
16. Using digital multimeter
Continuity - Proceed to step 17.
Pressure Solenoid Current
(WP 0283), test for continuity
No Continuity - Replace platform wir-
Below Normal - Continued
between pin 3 on platform har-
ing harness (WP 0150, WP 0155).
ness ECM J2 connector PL-C5
Ensure all harness connectors are
(WP 0018, Figure 218) and pin 11
reconnected. Verify proper operation
on platform harness to engine
of machine (TM 5-2410-240-10).
harness connector PL-C15
(WP 0018, Figure 225).
17. Using digital multimeter (WP
Continuity - Proceed to step 18.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 4 on platform harness ECM J2
ing harness (WP 0150, WP 0155).
connector PL-C5 (WP 0018, Fig-
Ensure all harness connectors are
ure 218) and pin 18 on platform
reconnected. Verify proper operation
harness to engine harness con-
of machine (TM 5-2410-240-10).
nector PL-C15 (WP 0018, Figure
225).
18. Using digital multimeter
No Continuity - Proceed to step 19.
(WP 0283), test for continuity
Continuity - Replace platform wiring
between pin 3 on platform har-
harness (WP 0150, WP 0155).
ness ECM J2 connector PL-C5
Ensure all harness connectors are
(WP 0018, Figure 218) and all
reconnected. Verify proper operation
other pins on platform harness
of machine (TM 5-2410-240-10).
ECM J2 connector PL-C5 (WP
0018, Figure 218).
19. Using digital multimeter
No Continuity - Replace machine
(WP 0283), test for continuity
ECM (WP 0147, WP 0149). Ensure all
between pin 3 on platform har-
harness connectors are reconnected.
ness ECM J2 connector PL-C5
Verify proper operation of machine
(WP 0018, Figure 218) and all
(TM 5-2410-240-10).
other pins on platform harness
Continuity - Replace platform wiring
ECM J1 connector PL-C4
harness (WP 0150, WP 0155).
(WP 0018, Figure 217).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
N OT E
0133-06 Transmission Pilot
Pressure Solenoid Current
Always inspect harness connectors that are involved in circuit. Poor
Above Normal
connections can often be the cause of an electrical circuit problem.
Verify that all connections in circuit are clean, secure, and connections
are in good condition. If a problem with a connection is found, correct
problem and verify diagnostic code is active before performing this
procedure.
Tag wiring harnesses to aid installation.