TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
0133-03 Transmission Pilot
11. Using digital multimeter
Continuity - Proceed to step 12.
Pressure Solenoid Voltage
(WP 0283), test for continuity
No Continuity - Replace platform wir-
Above Normal - Continued
between pin 3 on platform har-
ing harness (WP 0150, WP 0155).
ness ECM J2 connector PL-C5
Ensure all harness connectors are
(WP 0018, Figure 218) and pin 11
reconnected. Verify proper operation
on platform harness to engine
of machine (TM 5-2410-240-10).
harness connector PL-C15
(WP 0018, Figure 225).
12. Using digital multimeter
No Continuity - Proceed to step 13.
(WP 0283), test for continuity
Continuity - Replace platform wiring
between pin 3 on platform har-
harness (WP 0150, WP 0155).
ness ECM J2 connector PL-C5
Ensure all harness connectors are
(WP 0018, Figure 218) and all
reconnected. Verify proper operation
other pins on platform harness
of machine (TM 5-2410-240-10).
ECM J2 connector PL-C5
(WP 0018, Figure 218).
13. Using digital multimeter (WP
No Continuity - Replace machine
0283), test for continuity between
ECM (WP 0147, WP 0149). Ensure all
pin 3 on platform harness ECM J2
harness connectors are reconnected.
connector PL-C5 (WP 0018,
Verify proper operation of machine
Figure 218) and all other pins on
(TM 5-2410-240-10).
platform harness ECM J1 connec-
Continuity - Replace platform wiring
tor PL-C4 (WP 0018, Figure 217).
harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper operation
of machine (TM 5-2410-240-10).
N OT E
0133-05 Transmission Pilot
Pressure Solenoid Current
Always inspect the harness connectorsthat are involved in the circuit.
Below Normal
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean, secure and
that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016). Select
0133-05 Code Active - Proceed to
machine control ECM and check
step 2.
for diagnostic codes (WP 0013).
No Codes Active - The problem does
not exist at this time. Resume normal
operation.
2. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-240-10).