TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1708-06 Proportional Sole-
7. Using digital multimeter (WP
Continuity - Proceed to step 8.
noid Valve (Right Drive
0283), test for continuity between
No Continuity - Replace chassis har-
Motor) Current Above Nor-
pin 26 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
mal - Continued
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 1
Verify proper operation of machine
on pump harness RH drive motor
(TM 5-2410-240-10).
solenoid connector CH-C5 (WP
0018, Figure 84).
8. Using digital multimeter (WP
Continuity - Proceed to step 9.
0283), test for continuity between
No Continuity - Replace chassis har-
pin 17 on chassis harness to plat-
ness (WP 0153, WP 0154). Ensure all
form harness connector CH-C1
harness connectors are reconnected.
(WP 0018, Figure 81) and pin 2
Verify proper operation of machine
on pump harness RH drive motor
(TM 5-2410-240-10).
solenoid connector CH-C5 (WP
0018, Figure 84).
9. Using digital multimeter (WP
No Continuity - Proceed to step 10.
0283), test for continuity between
Continuity - Replace chassis harness
pin 26 on chassis harness to plat-
(WP 0153, WP 0154). Ensure all har-
form harness connector CH-C1
ness connectors are reconnected.
(WP 0018, Figure 81) and all
Verify proper operation of machine
other pins on chassis harness to
(TM 5-2410-240-10).
platform harness connector CH-
C1 (WP 0018, Figure 81).
10. Disconnect platform harness
ECM J1 connector PL-C4
(WP 0018, Figure 217) from
machine ECM (WP 0147, WP
0149).
11. Disconnect platform harness
ECM J2 connector PL-C5 (WP
0018, Figure 218) from machine
ECM (WP 0147, WP 0149).
12. Using digital multimeter
Continuity - Proceed to step 13.
(WP 0283), test for continuity
No Continuity - Replace platform wir-
between pin 59 on platform har-
ing harness (WP 0150, WP 0155).
ness ECM J1 connector PL-C4
Ensure all harness connectors are
(WP 0018, Figure 217) and pin 26
reconnected. Verify proper operation
on platform harness to chassis
of machine (TM 5-2410-240-10).
harness connector PL-C18 (WP
0018, Figure 226).
0020-128