TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1885-06 Winch Spool Out
3. Disconnect platform wiring har-
Solenoid Current Above
ness connector PL-C5 (WP 0018,
Normal - Continued
Figure 218) from ECM J2 (WP
0149).
4. Disconnect platform wiring har-
ness connector PL-C4 (WP 0018,
Figure 217) from ECM J1 (WP
0149).
5. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 6.
PL-C2 terminal 32 and all other
Continuity on One or More Test
circuits in PL-C2 (WP 0018, Fig-
Points - Replace platform wiring har-
ure 215).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Install right side debris guards (WP
0187).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
6. Using digital multimeter (WP
No Continuity on Any Test Points -
0283), test for continuity between
Proceed to step 7.
PL-C2 terminal 32 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C5
Points - Replace platform wiring har-
(WP 0018, Figure 218).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Install right side debris guards (WP
0187).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
0023-125