TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1885-06 Winch Spool Out
7. Using digital multimeter (WP
No Continuity on Any Test Points -
Solenoid Current Above
0283), test for continuity between
Proceed to step 8.
Normal - Continued
PL-C2 terminal 32 (WP 0018, Fig-
Continuity on One or More Test
ure 215) and all circuits in PL-C4
Points - Replace platform wiring har-
(WP 0018, Figure 217).
ness (WP 0155).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Install right side debris guards (WP
0187).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
8. Using digital multimeter (WP
No Continuity on Test Point -
Replace equipment ECM (WP 0148).
0283), test for continuity between
PL-C2 terminal 32 (WP 0018, Fig-
Connect platform wiring harness con-
ure 215) and ground.
nector PL-C5 (WP 0018, Figure 218)
on ECM J2 (WP 0149).
Connect platform wiring harness con-
nector PL-C4 (WP 0018, Figure 217)
on ECM J1 (WP 0149).
Connect engine wiring harness con-
nector EN-C50 (WP 0018, Figure
140) on platform wiring harness con-
nector PL-C32 (WP 0018, Figure 232)
(WP 0046).
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Install right side debris guards (WP
0187).
Install front floor plate (WP 0205).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
0023-126