TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1885-06 Winch Spool Out
Continuity on Test Point - Replace
Solenoid Current Above
platform wiring harness (WP 0155).
Normal - Continued
Connect pump wiring harness con-
nector PH-C1 (WP 0018, Figure 205)
on engine wiring harness connector
EN-C21 (WP 0018, Figure 137) (WP
0046).
Connect pump wiring harness con-
nector PH-C9 on reel-out solenoid
(WP 0018, Figure 213) (WP 0267).
Install right side debris guards (WP
0187).
Install front floor plate (WP 0205).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 9.
9. Using MSD (WP 0016), select
Code 1885-06 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 1885-06 is not active.
Code 1885-06 Not Active - Trouble-
shooting complete.
1885-13 Winch Spool Out
Test Step 1. Check for Active Cali-
Solenoid Out of Calibration
bration Code.
1. Connect MSD (WP 0016). Select
machine control D6K ECM and
verify 1885-13 is active.
2. Perform calibration of winch
spool-out solenoid (WP 0033).
3. Check for active code 1885-13 in
Code 1885-13 Remains Active - Pro-
machine control D6K ECM (WP
ceed to Test Step 2.
Code 1885-13 Becomes Inactive -
Troubleshooting complete.
Test Step 2. Verify Equipment ECM
Is Programmed Correctly.
1. Verify equipment (Implement
Software Correct - Replace equip-
Control #2) ECM is flashed with
ment ECM (WP 0148).
correct software (WP 0017).
Proceed to step 2.
Software Incorrect - Flash equip-
ment (Implement Control #2) ECM
with correct software (WP 0017). Pro-
ceed to step 2.